October 26, 2009 – 10:53 am
Are you still manufacturing wind towers with a normal plate roll? Are you still dealing with long manufacturing times, high labor costs, and facility requirements?
What if you didn’t have too?
Read More »
October 21, 2009 – 10:37 am
An Interview with Tony Wells
The old adage…”A plate roll is just a plate roll” could no longer be further from the truth. Today’s fabricators face the same challenges of other market segments, such as: reduced skill in the labor pool and the requirement for lower overhead and increasing productivity to compete with the ever expanding global market. At the same time, finished fabricated products are becoming more complex and automation requirements are now becoming mainstream solutions even in the world of plate fabrication. Tony Wells, Davi’s Business Development Manager talks about some of the advantages Davi rolls provide. Read More »
October 19, 2009 – 9:15 am
East End Welding
“Right now, we’re running our Mazak SpaceGear nearly 24 hours a day, with a 2 -3 week backlog,” said East End Welding Vice President Dave Dockery, “although we usually maintain 60 to 80 hours per week on it.” Not bad for a company that bought their SpaceGear in the middle of a recession without a single 3D job to run on it. Read More »
October 16, 2009 – 9:24 am
CUT FASTER | LOWER COSTS | INCREASE PRODUCTION
Flow Waterjet HyperPressure Technology, The Most Advanced and Robust High Pressure System Available. Read More »
October 14, 2009 – 8:51 am
Complete Fusion from 3D Laser Cutting to Tapping
The FabriGear series of cutting lasers – specifically designed for efficient, single-setup processing of both long- and short-tube, pipe, and structural components – now can be ordered with a tapping tool system, further enhancing its capabilities. Read More »