Mazak Load Unload System

mazak load unload

One of the easiest ways to automate your laser cutting process. The Mazak Load Unload system automatically loads, laser cuts, and unloads material in fast, efficient process.

Benefits of the Mazak Load/Unload System

  • Transports, positions, cuts, and stacks the finished material – Automatically
  • Runs unattended
  • Decreases material handling and potential injury






Automated Unattended Laser Processing

Fast, efficient, pneumatic Mazak Load Unload System automatically picks up a single sheet of material at a time, positions it correctly on the laser, then automatically stacks the cut sheets.

A load unit picks up an uncut sheet from the queue station and delivers it to the laser. However, the load and unload units travel together on the same monorail. More compact and efficient than separate carriers, this one-pass system shortens laser-idle time, plus minimizes adjustments and maintenance.

To ensure that only ONE sheet has been lifted Mazak’s system incorporates a magnetic fanner, a double-sheet separator, and a suction cup that pulls a corner of the top sheet away from a stack, and sensors for single sheet confirmation. If the sensors detect a double thickness, they can stop the system and sound an alarm.

Once cutting is finished, closely spaced tines on 2″ centers pick up cut sheets and carry them to the unload table. It handles any part geometry including small parts, any material thickness up to 3/4″ and any material type, including non-ferrous – with no additional setup.